Sailing hydrofoil

A sailing hydrofoil, hydrofoil sailboat, or hydrosail is a sailboat with wing-like foils mounted under the hull. As the craft increases its speed the hydrofoils lift the hull up and out of the water, greatly reducing wetted area, resulting in decreased drag and increased speed. A sailing hydrofoil can achieve speeds exceeding twice the wind speed.

Both monohull and multihull sailboats can be retrofitted with hydrofoils, although greater stability can be achieved by using the wider planform of a catamaran or trimaran.

Some multihulls use three foils; two main forward foils provide lift so that the boat "flies" while a horizontal foil on the rudder is trimmed to drive and control altitude. On catamarans, a single main foil can be attached between the hulls just in front of the center of gravity and at 2 degrees of incidence, spanning the tunnel with supporting struts. Hydrofoil catamarans are also called foilcats.

Multihull sailboats can also employ hydrofoils only to assist performance. Just as daggerboards and rudders are foils that enhance the control of a boat, assisting hydrofoils provide lift to the hull to reduce the wetted area without actually lifting the boat completely out of the water.

Monohull boats typically employ a "ladder" arrangement of hydrofoils splayed out with a dihedral angle of 50 degrees, with a stabilizing rudder foil. One of the earliest examples is the Monitor boat from 1957. This design offers the advantages of maximum lifting foil area at slow speeds and less at higher speeds, with rolling resistance arising from the dihedral support of the outboard ladder foils.

The most widespread use of hydrofoils in sailboats to date has been in the International Moth class. Andy Paterson of Bloodaxe boats on the Isle of Wight is widely considered to have developed the first functional foiling Moth, though his boat had three foils in a tripod arrangement. Brett Burvill sailed a narrow skiff Moth with inclined surface-piercing hydrofoils to a race win at the Moth World Championships in 2001 in Australia, which was the first time a hydrofoil Moth had won a race at a World Championship. This hydrofoil configuration was later declared illegal by the class, as it was felt to constitute a multihull, which is prohibited by class rules. Initially Ian Ward in Sydney, Australia developed the first centerline foiling Moth which demonstrated that sailing on centerboard and rudder foils alone was feasible. Subsequently, Garth and John Ilett in Perth, Australia developed a two-hydrofoil system for the Moth with active flap control for the main foil via a surface sensor. John's company Fastacraft was the first to produce a commercially available hydrofoil International Moth. Fasta Craft's Prowler design, superseded in 2008 by the F-Zero, features a carbon-fiber hull, inverted "T" foils on the centerboard and rudder, and can reach speeds of over 27 knots. Fasta Craft has since been joined in producing hydrofoil Moths by several other companies, including Bladerider, Assassin, Exocet, and Aardvark Technologies.

...
Wikipedia