Bristol 223
| Type 223 | |
|---|---|
 |
|
| Role | Supersonic transport |
| National origin | United Kingdom |
| Designer | Archibald Russell |
| Built by | Bristol Aeroplane Company |
| Number built | 0 |
| Developed into | Concorde |
The Bristol Aeroplane Company Type 223 was an early design for a supersonic transport. In the late 1950s and early 1960s the company studied a number of models as part of a large British inter-company effort funded by the government. These models eventually culminated in the Type 223, a transatlantic transport for about 100 passengers at a speed around Mach 2. At about the same time Sud Aviation in France was developing the similar Super-Caravelle design, and in November 1962 the efforts were merged to create the Concorde project.
In the UK, as elsewhere in the 1950s, the aero industry had been producing a series of supersonic test aircraft and had extensively studied the problems of sustained high-speed flight. By the mid-1950s, two designs had been shown to have a lift-to-drag ratio suitable for supersonic cruise, a sharply swept M-wing pioneered at Armstrong-Whitworth for slightly-supersonic flight and very slender delta wings suitable for a wide range of speeds. Higher speeds up to Mach 3 had been considered and found to be possible, but it appeared that a practical upper limit was Mach 2.2; above this speed the duralumin used for most aircraft construction would start to soften due to the heat of friction, and some new material would have to be used instead.
By 1956 there was enough official interest in this research for the Supersonic Transport Aircraft Committee, or STAC, to be formed under Sir Morien Morgan to investigate the creation of a supersonic transport. Its first report, in 1959, recommended two designs. One was an M-wing Mach 1.2 medium range airliner and the other a straight wing, Mach 1.8 design with six wingtip engines. Soon after, however, studies at the Royal Aircraft Establishment began to favour the gothic delta and design contracts using this planform went to Hawker Siddeley and Bristol in late 1959. Both were asked to look at both Mach 2.2 aluminium alloy and Mach 2.7 stainless steel structures. Bristol's Mach 2.7 design was labelled the Type 213. Their designer, Archibald Russell, was influenced by the constructional problems and expense encountered with the Bristol 188 and favoured the lower speed alloy aircraft.
...
Wikipedia