EMD GP40-2

EMD GP40-2

A pair of EMD GP40-2 coupled back-to-back for use in remote control switching operations - Tampa, Florida.

Type and origin Power type Diesel-electric Builder General Motors Electro-Motive Division General Motors Diesel (GMD) Model GP40-2 Build date 1972 - 1986 Total produced 1,143

Specifications AAR wheel arr. B-B Gauge 4 ft 8 1⁄2 in (1,435 mm) standard gauge Prime mover EMD 645E3 Aspiration Turbocharged Cylinders 16

Performance figures Power output 3,000 hp (2.24 MW)

The EMD GP40-2 is a 4-axle diesel road switcher locomotive built by General Motors Electro-Motive Division as part of its Dash 2 line between April 1972 and December 1986. The locomotive's power is provided by an EMD 645E3 16-cylinder engine which generates 3,000 horsepower (2.24 MW).

Standard GP40-2 production totalled 861 units, with 817 built for U.S. railroads, and 44 for Mexican roads. In addition, three GP40P-2s, passenger versions of the GP40-2, were built for Southern Pacific in 1974, and 279 GP40-2L(W) and GP40-2(W) units, equipped with wide-nosed cabs, were built by General Motors Diesel (GMD), for Canadian National and GO Transit between 1974 and 1976. Of the CN units, 233 were built with a taller and lighter frame to allow for a larger fuel tank. These units were officially classified GP40-2L but are commonly referred to as GP40-2L(W). The balance of CN's fleet, 35 units, and the 11 unit GO Transit fleet, used standard frames and smaller fuel tanks; they are often referred to as GP40-2(W) but are classified as GP40-2. Total production of the GP40-2 and its variations totalled 1,143 units.

Although the GP40-2 was a sales success, it sold fewer units than the earlier GP40 and the contemporary GP38-2 and SD40-2 models. The popularity of high-horsepower 4-axle diesels began to decline with the GP40-2, with 6-axle models gaining in popularity for their superior low-speed lugging performance.

Like the SD40-2 the GP40-2 has a reputation for reliability, and many are still in use. Changes such as the modular electronics system improved reliability over the GP40. Their high power-per-axle rating suited them to high-speed service rather than low-speed drag freights.

With the usual 62:15 gearing (65-70 mph maximum) EMD rated the GP40-2 at 55,400 lb continuous tractive effort; for compatibility with other units, most (all?) had the PF21 module that reduced horsepower below 23 mph, bringing the minimum continuous speed down to 11 mph.