Darcy (unit)
A darcy (or darcy unit) and millidarcy (md or mD) are units of permeability, named after Henry Darcy. They are not SI units, but they are widely used in petroleum engineering and geology. Like some other measures of permeability, a darcy has dimensional units in length².
Permeability measures the ability of fluids to flow through rock (or other porous media). The darcy is defined using Darcy's law, which can be written as:
where:
The darcy is referenced to a mixture of unit systems. A medium with a permeability of 1 darcy permits a flow of 1 cm³/s of a fluid with viscosity 1 cP (1 mPa·s) under a pressure gradient of 1 atm/cm acting across an area of 1 cm².
Typical values of permeability range as high as 100,000 darcys for gravel, to less than 0.01 microdarcy for granite. Sand has a permeability of approximately 1 darcy.
The darcy is named after Henry Darcy. Rock permeability is usually expressed in millidarcys (md) because rocks hosting hydrocarbon or water accumulations typically exhibit permeability ranging from 5 to 500 md.
The odd combination of units comes from Darcy's original studies of water flow through columns of sand. Water has a viscosity of 1.0019 cP at about room temperature.
The unit is named after Henry Darcy, and the unit abbreviation is not capitalized (contrary to industry use). The American Association of Petroleum Geologists use the following unit abbreviations and grammar in their publications:
Converted to SI units, 1 darcy is equivalent to 9.869233×10−13m² or 0.9869233 (µm)². This conversion is usually approximated as 1 (µm)². Note that this is the reciprocal of 1.013250—the conversion factor from atmospheres to bars.
...
Wikipedia