*** Welcome to piglix ***

Bumper block


A buffer stop or bumper, bumping post, or stopblock (US), is a device to prevent railway vehicles from going past the end of a physical section of track.

The design of the buffer stop is dependent, in part, on the kind of couplings that the railway uses, since the coupling gear is the first part of the vehicle that the buffer stop touches. The term "buffer stop" is of British origin, since railways in Great Britain principally use buffer-and-screw couplings between vehicles.

Several different types of buffer stop have been developed. They differ depending on the type of coupler used and on the intended application.

If there is extra room behind the bumper block, there is usually a sand or ballast drag that is designed to further retard a runaway train. One such accident occurred when a Northern Line train powered past the bumper block at Moorgate station in 1975 on the London Underground system.

Largely because of its mass, a train transfers an enormous amount of kinetic energy in a collision with a buffer stop. Rigid buffers can only safely cope with very low-speed impacts (i.e., nearly stationary). To improve stopping performance, a way of dissipating this energy is needed, through compression or friction. Following a buffer stop accident at Frankfurt am Main in 1902, the Rawie company developed a large range of energy-absorbing buffer stops. Similar hydraulic buffer stops were developed by Ransomes & Rapier in the UK.

When it is desired to slow or stop moving trains, without erecting a solid buffer stop, dowty retarders may be employed. They press upwards against the wheels, and may optionally be turned off as required.

Wheel stops are used to stop slow moving trains from continuing down a level track section.


...
Wikipedia

...