Zveno project

Zveno (Russian: Звено, Chain link or a military unit "Flight") was a parasite aircraft concept developed in the Soviet Union during the 1930s. It consisted of a Tupolev TB-1 or a Tupolev TB-3 heavy bomber acting as a mothership for between two and five fighters. Depending on the Zveno variant, the fighters either launched with the mothership or docked in flight, and they could refuel from the bomber. The definitive Zveno-SPB using a TB-3 and two Polikarpov I-16s, each armed with two 250 kg (550 lb) bombs, was used operationally with good results against strategic targets in Romania during the opening stages of the German-Soviet War. The same squadron afterwards also carried out a tactical attack against a bridge over the River Dnieper that had been captured by advancing German forces.

In June 1931, Vladimir Sergeyevich Vakhmistrov of the NII VVS (Nauchno-Issledovatel'skiy Institut Voyenno-Vozdushnykh Sil – scientific test institute of the air force) started work on combinations of fighters rigidly attached to heavy bomber aircraft. The system was envisioned to serve several purposes:

In all Zveno configurations, all aircraft were piloted and all had their engines running — it was expected that the combined thrust would more than offset the weight and actually improve the performance of the mothership compared to conventional bombers. The fighters were rigidly attached via pyramid-shaped metal frames, with both latches controlled by the fighter pilots. (On Zveno-1, the front latches were controlled by the bomber crew, while the back latch was controlled by the pilot; this was changed to all-pilot control in the next version). The original design included umbilical fuel lines which permitted the fighters to use fuel from the bomber while attached, although this was not fully implemented in practice.

The first successful flight of Zveno-1, using a Tupolev TB-1 mothership and two Tupolev I-4 fighters mounted on top of the wings, took place on 3 December 1931. An error in the sequence of opening the latches by the bomber crew resulted in one of the fighters prematurely separating, but the TB-1 with an I-4 attached to one of the wings remained in controlled flight and the second fighter was soon uneventfully deployed. After latch control was fully moved into the fighters, the normal launch procedure consisted of pilots opening the tail lock and then pulling on the control stick to open the front locks and separate from the bomber. As predicted, the presence of docked fighters had a minimal impact on performance of the mothership, and Zveno-2 Tupolev TB-3 carrying three Polikarpov I-5 fighters handled the same as an ordinary bomber. To mount the aircraft on the wings, they were pushed up special ramps but the centerline aircraft had to be lifted on top of the fuselage by hand. This was so cumbersome that the centerline I-5 became a permanent fixture on top of the Zveno-2 TB-3 and never started in the air. At one point, the centerline I-5, still with a pilot at the controls to operate the engine, had the wings and the tail surfaces removed and was used purely as fifth powerplant for the bomber mothership.

...
Wikipedia