*** Welcome to piglix ***

Wireless light switch


A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture:

Multiple wireless transmitters can command a single receiver. This means switches in different locations can turn the same electrical load on or off. Switching like this is often used in stairwells or rooms where two or more switches are used to turn one light on or off. Achieving this result with wired three-way or four-way switches requires a higher level of electrical knowledge and more time for wiring and installation.

Wireless light switches eliminate the wire from the light to the switch location. This is useful in remodeling situations where new wiring can be a hassle. Rather than tearing down a wall to gain access to the wires, a wireless switch can be used. This avoids any need to access wires and makes remodeling fast and simple.

Another use for wireless switches is in log homes, where electrical installations can be difficult because of the amount of routing and drilling that would otherwise be needed. When running a regular (non-wireless) circuit, the electrician must drill a hole through all of the logs to get each wire to the switch location. The electrician also must cut a large hole in the log to install a switch box. Wireless switches do not need switch boxes because there are no wires and no routing is needed. This decreases the electrical work required.

Installing a wired switch in a solid brick or concrete wall or installing on a plaster or tiled wall requires delicate routing and drilling to create a channel in the wall for the wire and space for the switch and switch box inside the wall. This routing and drilling work could damage the surface, causing expensive repair work. Wireless switches do not need any channels, holes, boxes or wire in the wall. This reduces the amount of electrical work required when installing a switch.


...
Wikipedia

...