Winder (machine)

A winding machine or winder is a machine for wrapping string, twine, cord, thread, yarn, rope, wire, ribbon, tape, etc. onto a spool, bobbin, reel, etc.

Winders are used heavily in textile manufacturing, especially in preparation to weaving where the yarn is wound onto a bobbin and then used in a shuttle. Ball winders are another type of winder that wind the yarn up from skein form into balls. Ball winders are commonly used by knitters and occasionally spinners.

Winders have a center roll (a bobbin, spool, reel, belt-winding shell, etc.) on which the material is wound up. Often there are metal bars that travel through the center of the roll, and are shaped according to their intended purpose. A circular bar facilitates greater speed, while a square bar provides a greater potential for torque. Edge sensors are used to sense how full the center roll is. They are mounted on adjustable slides to accommodate many different widths, as the width increases as the center roll is filled. The sensitivity of the sensor depends on the required speed of operation.

Winding machines are classified based on the materials they are winding, some major types are

On the basis of working the winders are classified as follows

The benefits of automatic splicing add up to significantly increased productivity, greater quality control and reduced waste. It consists of a tail grabber and automatic diameter calculated splice initiation technique. The precision shear wheel and anvil mechanism guarantees a clean cut and no overlap. The splicing technique is divided into two major categories based on the type of joint, they are, Butt splicing where adhesives are used and Lap splicing:lap joint by means of applying heat and pressing it.

Some winders have sensors built in to monitor the web (thread, wire, etc. that is being wound). There are three common types of sensors:

An optical sensor is placed above or under the web to be controlled. Standard sensors are not affected by dirt, steam or temperatures up to 160 degrees Celsius. Optical sensors work by sending a beam of light at the web, and seeing if the light is reflected or not.

It consists of a knife blade which is used to cut the web when the maximum roll diameter is reached. The knife blade is actuated either by means of pneumatic or electrical actuators.IT CO

The rolls have to be changed when the maximum roll diameter is reached this can be achieved either manually or automatically. The unit consists of a regulating circuit, which detects the web speed and speed of the carriage. The regulator sets the web speed and speed of the carriage by comparing the web tension with an adjustable web tension set point. Modern automated winders are capable of reasonable high speed roll set change and core introduction, Tissue winders making toilet roll can change over at running speed, Paper and board winders need to stop the winding process to cut the sheet and glue the paper on to a new wind up core, Top line winders introduce the paper core through a maintenance pit down stairs, with web interruption time as low as 15 seconds, More traditional, winders actual web stopped set turn out change time can be as low as 45 seconds, these modern change efficiency upgrades, make it possible for mills to maintain production over one winder for each paper machine and still carry out maintenance with out risk to product quality.

...
Wikipedia