Weaver rail mount

A Weaver rail mount is a system to connect telescopic sights and other accessories to rifles, shotguns, pistols, and crossbows. It uses a pair of parallel rails and several slots perpendicular to these rails.

The later Picatinny rail, developed by the US military, is a development of the key concepts of the Weaver system, and they are partly compatible.

The Weaver mount was developed by William Ralph Weaver (1905 – 8 November 1975) at his telescopic sight company W.R. Weaver Co., which he founded in 1930. Previous systems included the Leupold/Redfield mounts. Compared to the Leupold mount, the Weaver rail is not as strong and cannot be adjusted for windage.

W.R. Weaver Co. became Weaver Optics, and was a subsidiary of Meade Instruments Corporation from 2002 to 2008, when it was on-sold to become part of Alliant Techsystems's Security and Sporting division in Onalaska, Wisconsin.

Older Weaver systems used two pieces mounted a distance apart from one another typically on the receiver of a rifle over the bolt opening where the cartridge would be inserted and/or ejected. However, alignment problems of the two piece system can put undue stress on a rifle scope and cause problems between the scope and rifle barrel parallels and bullet Point Of Impact (POI). Also the two piece system must be mounted to exacting tolerances to one another to ensure perfect alignment using a scope alignment device called Alignment Sleeves. The two piece type can also be problematic when some rifles will not allow for the two pieces to be mounted due to metal thickness of the receiver or other issues of receiver length that will not allow for proper distance to hold the scope. With the later one piece approach, the rail system remains consistent in alignment.

The slots on a Weaver system are primarily used as a clearance of the locking screw that tightens the clamp to the rail. Some Weaver-type accessories have a bar that fits inside the machined slots on the rails while many others do not.

Weaver rails have a slot width of 0.180 in (4.57 mm), but are not necessarily consistent in the spacing of slot centers.

The lack of a locking bar on many Weaver-type accessories also lends to another alignment issue: Canting. Though this problem is not common it can be very problematic especially with scopes. Because scopes need to be mounted to a rifle in perfect parallel to the barrel and to ensure the cross hairs sit exactly where a bullet will go (POI), a small variation of even ¼ of one degree can cause massive problems at longer ranges. The locking bar holds the mount in a perfect 90 degree to the rail system where as a non-locking bar system can cant to the left or right. This canting (sometimes called jamming of surfaces) is caused by not matching the clamping surface perfectly to the rail. When tightened down, stress exerted on the base can cause the scope to be off from the POI by as much as several feet at 100–200 yards and gets progressively worse the farther out the range goes. Lower grade materials used in manufacturing of scope bases, inconsistent design tolerances from one manufacturer to another and other factors can cause twisting stress and cause the mount to move out of parallel with the rifle barrel. The locking bar system allows for even stress to be distributed and prevent canting of the scope mount.

...
Wikipedia