Visual servo

Visual servoing, also known as vision-based robot control and abbreviated VS, is a technique which uses feedback information extracted from a vision sensor (visual feedback) to control the motion of a robot. One of the earliest papers that talks about visual servoing was from the SRI International Labs in 1979.

There are two fundamental configurations of the robot end-effector (hand) and the camera:

Visual Servoing control techniques are broadly classified into the following types:

IBVS was proposed by Weiss and Sanderson. The control law is based on the error between current and desired features on the image plane, and does not involve any estimate of the pose of the target. The features may be the coordinates of visual features, lines or moments of regions. IBVS has difficulties with motions very large rotations, which has come to be called camera retreat.

PBVS is a model-based technique (with a single camera). This is because the pose of the object of interest is estimated with respect to the camera and then a command is issued to the robot controller, which in turn controls the robot. In this case the image features are extracted as well, but are additionally used to estimate 3D information (pose of the object in Cartesian space), hence it is servoing in 3D.

Hybrid approaches use some combination of the 2D and 3D servoing. There have been a few different approaches to hybrid servoing

The following description of the prior work is divided into 3 parts

Visual servo systems, also called servoing, have been around since the early 1980s , although the term visual servo itself was only coined in 1987. Visual Servoing is in essence a method for robot control where the sensor used is a camera (visual sensor). Servoing consists primarily two techniques, one involves using information from the image to directly control the degrees of freedom (DOF) of the robot, thus referred to as Image Based Visual Servoing (IBVS). While the other involves the geometric interpretation of the information extracted from the camera, such as estimating the pose of the target and parameters of the camera (assuming some basic model of the target is known). Other servoing classifications exist based on the variations in each component of a servoing system , e.g. the location of the camera, the two kinds are eye-in-hand and hand–eye configurations. Based on the control loop, the two kinds are end-point-open-loop and end-point-closed-loop. Based on whether the control is applied to the joints (or DOF) directly or as a position command to a robot controller the two types are direct servoing and dynamic look-and-move. Being one of the earliest works the authors proposed a hierarchical visual servo scheme applied to image-based servoing. The technique relies on the assumption that a good set of features can be extracted from the object of interest (e.g. edges, corners and centroids) and used as a partial model along with global models of the scene and robot. The control strategy is applied to a simulation of a two and three DOF robot arm.

...
Wikipedia