Twin-lead

Twin-lead cable is a two-conductor flat cable used as a transmission line to carry radio frequency (RF) signals. It is constructed of two multistranded copper or copperclad steel wires, held a precise distance apart by a plastic (usually polyethylene) ribbon. The uniform spacing of the wires is the key to the cable's function as a parallel transmission line; any abrupt changes in spacing would reflect some of the signal back toward the source. The plastic also covers and insulates the wires.

The characteristic impedance of twin-lead is a function of the wire diameter and its spacing; in 300 ohm twin-lead, the most common type, the wire is usually 20 or 22 gauge, about 7.5 mm (0.30 inches) apart. This is well matched with the natural impedance of a folded dipole antenna, which is normally around 275 ohms. Twin-lead generally has higher impedance than the other common transmission wiring, coaxial cable (coax). The widely used RG-6 coax has a characteristic impedance of 75 ohms, which requires the use of a balun to match impedance when used with common antenna types.

Twin lead also has significantly lower signal losses than coax under most conditions; RG-58 coax loses 6.6 dB per 100 m at 1 GHz, while 300 ohm twin-lead loses only 0.55 dB. However, twin-lead is more vulnerable to interference. For instance, proximity to nearby metal objects will inject signals into twin-lead that would be filtered out by coax, requiring careful installation around rain gutters, and standoffs from support masts. Twin-lead is also susceptible to significant degradation when wet or ice covered, whereas coax is less or not affected in these conditions. For these reasons, coax has largely replaced twin-lead in most uses, except where maximum signal is required.

Twin lead and other types of parallel-conductor transmission line are mainly used to connect radio transmitters and receivers to their antennas. Parallel transmission line has the advantage that its losses are an order of magnitude smaller than coaxial cable, the main alternative form of transmission line. Its disadvantages are that it is more vulnerable to interference, and must be kept away from metal objects which can cause power losses. For this reason, when installed along the outside of buildings and on antenna masts, standoff insulators must be used. It is also common practice to twist the twin lead on long free standing lengths to further reject any induced imbalances to the line.

...
Wikipedia