Threaded Neill-Concelman connector

TNC

TNC connector on the left beside BNC.
Type	RF coaxial connector
Designer	Paul Neill and Carl Concelman
Designed	Late 1950s
Manufacturer	Various
Diameter	Male: 0.590 in (15.0 mm) Female: 0.378 in (9.6 mm) (outer, typical) Thread 7/16-28 UNEF
Cable	Coaxial
Passband	Typically 0-11 GHz

The TNC (Threaded Neill–Concelman) connector is a threaded version of the BNC connector. The connector has a 50 Ω impedance and operates best in the 0–11 GHz frequency spectrum. It has better performance than the BNC connector at microwave frequencies. Invented in the late 1950s and named after Paul Neill of Bell Labs and Carl Concelman of Amphenol, the TNC connector has been employed in a wide range of radio and wired applications.

The abbreviation TNC is sometimes given as standing for 'Threaded Navy Connector'.

Reverse-polarity TNC (RP-TNC, sometimes RTNC) is a variation of the TNC specification which reverses the polarity of the interface. This is usually achieved by incorporating the female contacts normally found in jacks into the plug, and the male contacts normally found in plugs into the jack.

Because they were not readily available, RP-TNC connectors have been widely used by Wi-Fi equipment manufacturers to comply with specific local regulations, such as those from the FCC, which are designed to prevent consumers from connecting antennas which exhibit gain and therefore breach compliance. The FCC considered that the RP-TNC was acceptable in preventing consumers changing the antenna; but by 2000 it regarded them as readily available, though delaying its ruling indefinitely. As of 2013, leading manufacturers are still using RP-TNC connectors on their Wi-Fi equipment.

Most TNC connectors are 50-ohm type even when used with coaxial cable of other impedances, but a 75-ohm series is also available, providing a good SWR to about 1 GHz. These can be recognized by a reduced amount of dielectric in the mating ends. They are intermatable with standard types.