Stanley Motor Carriage Company
 |
|
| Industry | Automobile |
|---|---|
| Fate | Sold and dissolved |
| Founded | 1902 (first vehicle produced 1897) |
| Defunct | 1924 |
| Headquarters | Newton, Massachusetts, United States |
|
Key people
|
Francis Edgar Stanley and Freelan O. Stanley |
| Products | Vehicles |
The Stanley Motor Carriage Company was an American manufacturer of steam-engine vehicles; it operated from 1902 to 1924. The cars made by the company were colloquially called Stanley Steamers, although several different models were produced.
Twins Francis E. Stanley (1849–1918) and Freelan O. Stanley (1849–1940) founded the company after selling their photographic dry plate business to Eastman Kodak. They produced their first car in 1897. During 1898 and 1899, they produced and sold over 200 cars, more than any other U.S. maker. In 1899, Freelan and his wife Flora drove one of their cars to the top of Mount Washington in New Hampshire, the highest peak in the northeastern United States. The ascent took more than two hours and was notable as being the first time a car had climbed the 7.6 miles (12.2 km) long Mount Washington Carriage Road; the descent was accomplished by putting the engine in low gear and braking extensively. The twins later sold the rights to this early design to Locomobile, and in 1902 they formed the Stanley Motor Carriage Company.
Early Stanley cars had light wooden bodies mounted on tubular steel frames by means of full-elliptic springs. Steam was generated in a vertical fire-tube boiler, mounted beneath the seat, with a vaporizing gasoline (later, kerosene) burner underneath. The boiler was reinforced by several layers of piano wire wound around it, which gave it a strong, yet relatively light-weight, shell. In early models, the vertical fire-tubes were made of copper, and were expanded into holes in the upper and lower crown sheets. In later models, the installation of a condenser caused oil-fouling of the expansion joints, and welded steel fire-tubes were used instead. The boilers were safer than one might expect – they were fitted with safety valves, and even if these failed, a dangerous overpressure would rupture one of the many joints long before the boiler shell was in danger of bursting, and the resulting leak would relieve the boiler pressure and douse the burner with little risk to the occupants of the car. There has never been a documented case of a Stanley boiler exploding in use.
...
Wikipedia