Specific fuel consumption (thrust)

Thrust specific fuel consumption (TSFC) is an engineering term that is used to describe the fuel efficiency of an engine design with respect to thrust output. TSFC may also be thought of as fuel consumption (grams/second) per unit of thrust (kilonewtons, or kN). It is thus thrust-specific, meaning that the fuel consumption is divided by the thrust.

TSFC or SFC for thrust engines (e.g. turbojets, turbofans, ramjets, rocket engines, etc.) is the mass of fuel needed to provide the net thrust for a given period e.g. lb/(h·lbf) (pounds of fuel per hour-pound of thrust) or g/(s·kN) (grams of fuel per second-kilonewton). Mass of fuel is used rather than volume (gallons or litres) for the fuel measure since it is independent of temperature.

Specific fuel consumption of air-breathing jet engines at their maximum efficiency varies more or less inversely with speed, which means that the fuel consumption per mile or per km can be a more appropriate comparison for aircraft that travel at very different speeds.

This figure is inversely proportional to specific impulse.

SFC is dependent on engine design, but differences in the SFC between different engines using the same underlying technology tend to be quite small. Increasing overall pressure ratio on jet engines tends to decrease SFC.

In practical applications, other factors are usually highly significant in determining the fuel efficiency of a particular engine design in that particular application. For instance, in aircraft, turbine (jet and turboprop) engines are typically much smaller and lighter than equivalently powerful piston engine designs, both properties reducing the levels of drag on the plane and reducing the amount of power needed to move the aircraft. Therefore, turbines are more efficient for aircraft propulsion than might be indicated by a simplistic look at the table below.

SFC varies with throttle setting, altitude and climate. For jet engines, flight speed also has a significant effect upon SFC; SFC is roughly proportional to air speed (actually exhaust velocity), but speed along the ground is also proportional to air speed. Since work done is force times distance, mechanical power is force times speed. Thus, although the nominal SFC is a useful measure of fuel efficiency, it should be divided by speed to get a way to compare engines that fly at different speeds.

...
Wikipedia