Saw chain

The saw chain, or "cutting chain", is a key component of a chainsaw. It consists of steel links held together by rivets, and superficially resembles the bicycle-style roller chain, although it is closer in design to a leaf chain. Its key differences are sharp cutting teeth on the outside of the chain loop, and flat drive links on the inside, to retain the chain on the saw's bar and allow propulsion by the engine or motor.

Saw chains (and chainsaws generally) are used for cutting wood. This may be for harvesting trees for pulp or timber, for tree surgery, or for processing firewood.

Whether for hand-held chainsaws, mechanical timber harvesters or chain mortisers, the saw chain has undergone dramatic development since its invention. Modern chains designed for high power, high-speed sawing applications will vastly outperform older designs, while allowing a far greater degree of safety and reliability in use.

Saw chains operate by being propelled around a guide bar, removing material from the by cutting chips from the side and bottom. In order to operate properly, the depth to which each tooth cuts must be limited to avoid it binding in the wood. Scratcher chain, like the teeth on a hand saw, simply uses a multitude of teeth to prevent individual teeth from sinking too far in without undue pressure on the bar. Chipper chain, and all subsequent designs, incorporate a depth gauge (also known as a "raker") on each cutter link to limit depth of cut on each tooth. This has two distinct advantages over scratcher chain - it enables the use of fewer cutters per unit length of chain, which allows for shorter downtime for sharpening, and produces a more "open" chain layout, allowing far better clearance of chips and debris from the kerf. Individual depth gauges on each tooth also enable the use of skip chain. Skip or semi-skip chain has a further reduction in the number of teeth and is used for applications where much debris is produced, such as ripping or cross-cutting very large sections of wood. Skip chain also absorbs less power from the motor per unit length of chain than full-complement chain, allowing the use of a longer bar/chain combination on any given motor.

Very early chainsaws used tooth configurations very similar to conventional hand saws. These were very simple saw teeth following a wave pattern (left, centre, right, centre) with no depth gauges as such, relying purely on bar pressure to limit the cutting rate. They were inefficient and slow in use, and were soon superseded by chipper chain. They required great skill and a lot of time to sharpen in the field leading to extended downtime between sessions.

...
Wikipedia