Parabellum MG14

Parabellum MG14
Early version (1913), with electromagnetic trigger attached
Type	Aircraft machine gun
Place of origin	Germany
Service history
Wars	World War I
Production history
Designer	Karl Heinemann
Specifications
Weight	9.5 Kg
Length	122 cm
Barrel length	70 cm
Cartridge	8x57mm IS
Caliber	7.9mm
Rate of fire	600-700 rpm

The Parabellum MG14 was a 7.9 mm caliber World War I machine gun built by Deutsche Waffen und Munitionsfabriken. It was a redesign of the Maschinengewehr 08 machine gun (itself an adaptation of the Maxim gun) system intended for use on aircraft and zeppelins, that used a toggle action that broke upwards rather than downwards opposite the MG 08, making for a much more compact receiver. The fusee spring was dispensed with for an internal spring design, the breech block was completely different and the spent cartridges dropped out the bottom of the receiver rather than forward through a hole in receiver. There appears to be no action or receiver parts interchangeable with the MG 08. The MG08's belt-style ammunition feed was enclosed in a drum, the recoil casing was lightened and the cooling jacket was modified for air- instead of water-cooling. The rate of fire was 700 rounds/minute. The belt was reduced to 30 mm in width.

An MG14 was used in the early development of the German version of the gun synchroniser by Anthony Fokker. The MG14 was used with the first version of the pioneering Fokker Stangensteuerung synchronizer on the Fokker E.I pre-production prototypes but as the limited supplies of the weapon were more urgently needed for observers in reconnaissance aircraft and defensive gunners aboard Zeppelins and heavier-than-air bombers, it was reserved for flexible mounts where its combination of light weight and high rate of fire were most useful.

The MG 14 and following on MG 14/17 did make one important contribution to the fixed forward-firing LMG 08's and LMG's 08/15's in that their 30mm wide cloth ammunition belt was compatible with those weapons as the fixed forward-firing guns used fixed ammunition feed guides and if surviving photographs are to be used as a reference, the belts were used exclusively by the Deutsche Luftstreitkräfte for all fixed forward-firing guns. The belts can be readily identified by two grommets (instead of three for the wider MG 08 and MG 08/15 belts used by ground forces) and the lack of extended brass tab (also used by the MG 08 and Mg 08/15 ground guns). This not only reduced weight and bulk but it also allowed for much lighter and smaller empty belt chutes that came out of all LMG 08's and LMG 08/15's and led down into storage bins in the aircraft. At least three versions survive, a water cooled, an air cooled and a 14/17 version with a 3x telescopic sight.