Offset binary

Offset binary, also referred to as excess-K,excess-N, excess code or biased representation, is a digital coding scheme where all-zero corresponds to the minimal negative value and all-one to the maximal positive value. There is no standard for offset binary, but most often the offset K for an n-bit binary word is K = 2ⁿ⁻¹. This has the consequence that the "zero" value is represented by a 1 in the most significant bit and zero in all other bits, and in general the effect is conveniently the same as using two's complement except that the most significant bit is inverted. It also has the consequence that in a logical comparison operation, one gets the same result as with a two's complement numerical comparison operation, whereas, in two's complement notation a logical comparison will agree with two's complement numerical comparison operation if and only if the numbers being compared have the same sign. Otherwise the sense of the comparison will be inverted, with all negative values being taken as being larger than all positive values.

One historically prominent example of offset-64 (excess-64) notation was in the floating point (exponential) notation in the IBM System/360 and System/370 generations of computers. The "characteristic" (exponent) took the form of a seven-bit excess-64 number (The high-order bit of the same byte contained the sign of the significand).

The 8-bit exponent in Microsoft Binary Format, a floating point format used in various programming languages (in particular BASIC) in the 1970s and 1980s, was encoded using an offset-129 notation (excess-129).

The IEEE Standard for Floating-Point Arithmetic (IEEE 754) uses various sizes of exponent, but also uses offset notation for the format of each precision. Unusually however, instead of using "excess 2ⁿ⁻¹" it uses "excess 2ⁿ⁻¹ − 1" (i.e. excess-15, excess-127, excess-1023, excess-16383) which means that inverting the leading (high-order) bit of the exponent will not convert the exponent to correct two's complement notation.

Offset binary is often used in digital signal processing (DSP). Most analog to digital (A/D) and digital to analog (D/A) chips are unipolar, which means that they cannot handle bipolar signals (signals with both positive and negative values). A simple solution to this is to bias the analog signals with a DC offset equal to half of the A/D and D/A converter's range. The resulting digital data then ends up being in offset binary format.

...
Wikipedia