*** Welcome to piglix ***

Limiting


In electronics, a limiter is a circuit that allows signals below a specified input power or level to pass unaffected while attenuating the peaks of stronger signals that exceed this threshold. Limiting is a type of dynamic range compression. Clipping (audio) is an extreme version of limiting.

Limiting is any process by which a specified characteristic (usually amplitude) of the output of a device is prevented from exceeding a predetermined value.

Limiters are common as a safety device in live sound and broadcast applications to prevent sudden volume peaks from occurring. Limiters are also used as protective features in some components of sound reinforcement systems (e.g., powered mixing boards and power amplifiers) and in some bass amps, to prevent unwanted distortion or speaker damage.

Limiting can refer to non-linear clipping, in which a signal is passed through normally but "sheared off" when it would normally exceed a certain threshold. It can also refer to a type of variable-gain audio level compression, in which the gain of an amplifier is changed very quickly to prevent the signal from going over a certain amplitude.

Bass instrument amplifiers and power amplifiers are more commonly equipped with limiter circuitry to prevent overloading the power amplifier and to protect speakers. Electric guitar amps do not usually have limiters.

PIN diodes can be used in limiter circuits to reflect the energy back to the source or clip the signal.

An FM radio receiver usually has at least one stage of amplification for this purpose. It provides a constant level of signal to the FM demodulator stage, reducing the effect of signal level changes in the output. If two or more signals are received at the same time, a high performance limiter stage can greatly reduce the effect of the weaker signals on the output. This is commonly referred to as the FM capture effect.


...
Wikipedia

...