Krotekaker
 |
|
| Type | Flatbread |
|---|---|
| Place of origin | Norway |
| Region or state | Hardanger |
| Main ingredients | Flour, yeast, water |
 |
|
Krotekaker is a traditional flatbread from the Hardanger region of Norway. Outside of the region it is often known as hardangerkaker. The dried krotekaker can be made in quantity and stored without refrigeration for extended periods of time. Krotekake is a kind of lefse thin pastry. The name lefse covers many different kinds of thin or thick, soft or hard pastry. In the Norwegian language krote means "a scroll" and kake is a cake or pastry. A common misunderstanding is that all kind of lefse contains potatoes.
The making of krotekaker is more than a recipe. t is an opportunity for small gatherings of neighbors in this largely rural fjord coastline. There are typically three or four participants in this activity. The preparation and assembly can take much of the day and provides plenty of time to share stories and catch up on neighborhood information while producing a bounty of staple foodstuff.
The first step in the process is to mix a simple whole-wheat yeast dough and let it rise. One member of the team can often perform this basic step before the arrival of the rest of the participants.
The biscuit maker measures and forms the dough. A handful of dough approximately 1.5 inches (3.8 cm) in diameter is pulled from the whole. This is formed by turning the edges of the dough-ball down and tucking them into the middle of the bottom of the ball. If the ball feels sticky, the biskit maker adds a dusting of flour. A ball is formed which has been pulled smooth on top and has a dimple on the bottom. The ball is then placed on the floured surface — dimple down. The biscuit maker should have one or two of these finished balls ready so that they have a minute or two to rest before they are rolled.
The roller is responsible for shaping the round. A biscuit is rolled with a smooth round rolling pin until it is three or four inches (102 mm) in diameter and about 1/2 inch (125 mm) thick. It is then flipped over and rolled again until it is larger and thinner and shaped like a disk. At no time should the round stick to the pin or the table. If it appears to be getting sticky it should be flipped onto a new dusting of flour. The round is flipped and rolled and dusted until it is about 1/8 inch thick and twelve inches (305 mm) in diameter. If the round ends up sticking it needs to be scraped off the table or pin and placed back with the mass of dough.
Next the round is rolled with a special steel rolling pin. The pin has deep grooves about 1/8 inch wide and 1/8 inch apart. It is also cut laterally at 1/8 inch intervals. The pin presses creases into the round but because of the lateral grooves it does not cut the round into ribbons of dough. This pin is firmly rolled across the round and then again at right angles to the original direction leaving a cross-hatch pattern which seals the top and bottom surfaces of the round to each other. The round may also be slightly sealed to the tabletop. A lefse stick is a thin, flat, wooden stick with straight sides about 2 feet (0.61 m) long and 1½ inches wide which has been sanded smooth. This stick is used to slide under the krotekake to release it from the floured surface. It is also used to scrape the table or pin clean of dough.
...
Wikipedia