IBM 3420

The IBM System/360, released in 1964, introduced what is now generally known as 9 track tape. The ½ inch (12.7 mm) wide magnetic tape media and reels are the same size as the earlier IBM 7 track format it replaced, but the new format has eight data tracks and one parity track for a total of nine parallel tracks. Data is stored as 8-bit characters, spanning the full width of the tape (including the parity bit). Various recording methods were employed during its lifetime as tape speed and data density increased, including PE (phase encoding), GCR (group coded recording) and NRZI (non-return-to-zero, inverted, sometimes pronounced "nur-zee"). Tapes came in various sizes up to 3,600 feet (1,100 m) in length.

The standard size of a byte was effectively set at eight bits with the S/360 and nine-track tape.

For over 30 years the format dominated offline storage and data transfer, but by the end of the 20th century it was obsolete, and the last manufacturer of tapes ceased production in early 2002, with drive production ending the next year.

A typical 9-track unit consisted of a tape transport—essentially all the mechanics that moved tape from reel to reel past the read/write and erase heads—and supporting control and data read/write electronics. The transport typically consisted of supply motor, take-up motor, hubs for locking the tape reels in place, a capstan motor (though not necessarily a pinch roller, see below), tape head assembly, miscellaneous rollers which kept the tape in a precise path during operation, and vacuum columns which prevented tape 'snatch'. Data could become corrupted by stretched tape or variations in tape speed, so the transport had to guide the tape through without damaging its edges, move it with minimal wow and flutter, and give it a tension that was low but sufficient to keep the tape in constant contact with the read/write head.

To load a tape, an operator would remove the protective ring (frequently called a "tape seal belt" because its purpose was to prevent humidity and dust on the media) from the outside of the tape reel and install the tape on the supply hub, then thread the tape leader through the various roller assemblies and onto the take-up reel, installing three or four winds of tape to provide enough friction for the take-up motor to be able to pull the tape. The operator then initiated an automatic sequence, often by a single press of a button, that would start the vacuum system, then move the tape forward until the beginning-of-tape (BOT) foil strip was detected by an optical sensor in the tape path. The control electronics would then indicate to the controlling computer that the unit was ready for operation.

...
Wikipedia