*** Welcome to piglix ***

Geologic map


A geologic map or geological map is a special-purpose map made to show geological features. Rock units or geologic strata are shown by color or symbols to indicate where they are exposed at the surface. Bedding planes and structural features such as faults, folds, foliations, and lineations are shown with strike and dip or trend and plunge symbols which give these features' three-dimensional orientations.

Stratigraphic contour lines may be used to illustrate the surface of a selected stratum illustrating the subsurface topographic trends of the strata. Isopach maps detail the variations in thickness of stratigraphic units. It is not always possible to properly show this when the strata are extremely fractured, mixed, in some discontinuities, or where they are otherwise disturbed.

Rock units are typically represented by colors. Instead of (or in addition to) colors, certain symbols can be used. Different geologic mapping agencies and authorities have different standards for the colors and symbols to be used for rocks of differing types and ages.

Geologists take two major types of orientation measurements (using a hand compass like a Brunton compass): orientations of planes and orientations of lines. Orientations of planes are often measured as a "strike" and "dip", while orientations of lines are often measured as a "trend" and "plunge".

Strike and dip symbols consist of a long "strike" line, which is perpendicular to the direction of greatest slope along the surface of the bed, and a shorter "dip" line on side of the strike line where the bed is going downwards. The angle that the bed makes with the horizontal, along the dip direction, is written next to the dip line. In the azimuthal system, strike and dip are often given as "strike/dip" (for example: 270/15, for a strike of west and a dip of 15 degrees below the horizontal).


...
Wikipedia

...