General Electric J35
| J35 | |
|---|---|
 |
|
| The exhaust end of an Allison J35 | |
| Type | Turbojet |
| National origin | United States |
| Manufacturer |
General Electric Allison Engine Company |
| First run | 1946 |
| Major applications |
F-84 Thunderjet F-89 Scorpion |
| Developed into |
Allison J71 General Electric J47 |
The General Electric/Allison J35 was originally developed by General Electric (GE company designation TG-180) in parallel with the Whittle-based centrifugal-flow J33, and was the United States Air Force's first axial-flow (straight-through airflow) compressor engine. The J35 was fairly simple, consisting of an eleven-stage axial-flow compressor and a single-stage turbine. With the afterburner, which most models carried, it produced a thrust of 7,400 lbf (32.92 kN).
Like the J33, the design of the J35 originated at General Electric, but major production was by the Allison Engine Company.
While developing the T31 axial turboprop in 1943 GE realized that they had the resources to design an axial turbojet at the same time as their centrifugal J33 engine. They recognized the axial would have more potential for the future and went ahead with the TG-180 engine. GE axial compressor designs were developed from the NACA 8-stage compressor.
The engine had its starter and accessories (fuel control, fuel pump, oil pumps, hydraulic pump, RPM generator) mounted in the centre of the compressor inlet. This accessory layout, as used on centrifugal engines, restricted the area available for compressor inlet air. It was carried over to the J47 but revised (relocated to an external gearbox) on the J73 when a 50% increase in airflow was required. It also had an inlet debris guard which was common on early jet engines.
GE developed a variable afterburner for the engine, although electronic control linked with engine controls had to wait until the J47. Marrett describes one of the consequences if the link is human on an afterburning engine. If the afterburner lit but the nozzle didn't open (not noticed by the pilot) the RPM governor would overfuel the engine until the turbine failed.
The General Electric J35 first flew in the Republic XP-84 Thunderjet in 1946. Late in 1947, complete responsibility for the development and production of the engine was transferred to the Allison Division of the General Motors Corporation and some J35s were also built by GM's Chevrolet division. More than 14,000 J35s had been built by the time production ended in 1955.
...
Wikipedia