*** Welcome to piglix ***

Eiksund Bridge

Eiksund Bridge
Eiksundbrua
Eiksundbrua02.jpg
View of the opening of the bridge
Coordinates 62°14′47″N 05°53′44″E / 62.24639°N 5.89556°E / 62.24639; 5.89556Coordinates: 62°14′47″N 05°53′44″E / 62.24639°N 5.89556°E / 62.24639; 5.89556
Carries 653
Locale Ulstein Municipality, Norway
Characteristics
Design Cantilever bridge
Material Concrete
Total length 405 m (1,329 ft)
Width 9.3 m (31 ft)
Longest span 132 m (433 ft)
No. of spans 5
Clearance below 16 m (52 ft)
History
Construction end 2005
Construction cost NOK 86 million

The Eiksund Bridge (Norwegian: Eiksundbrua) is a cantilever bridge in Ulstein Municipality in the Sunnmøre region of Møre og Romsdal county, Norway. The bridge is connected to the Eiksund Tunnel as part of the Eiksund Sambandet which joins several islands in the municipalities of Ulstein, Herøy, Sande, and Hareid to the mainland, without the use of ferries.

The bridge runs from the village of Eiksund on Hareidlandet island to the western part of the island of Eika. The bridge is 405 metres (1,329 ft) long and 9.3 metres (31 ft) wide. It has 5 spans, of which the longest is 132 metres (433 ft). The sailing space underneath is 20 metres (66 ft) across, with a maximum height of 16 metres (52 ft).

The bridge was finished in 2005, but connections with the Eiksund Tunnel were not available until it officially opened in February 2008. Until then, only local traffic between Hareidlandet and Eika could use the bridge.

In February 2006, the Mechanical Contractors Association stated that Eiksund Bridge had been built too small, and was dangerous to use, especially in the snow.


...
Wikipedia

...