*** Welcome to piglix ***

Dobson ozone spectrophotometer


The Dobson spectrophotometer, also known as Dobsonmeter, Dobson spectrometer, or just Dobson is the earliest instrument used to measure atmospheric ozone. It was invented in 1924 by Gordon Dobson. A history of the development of the instrument is here and an example of one of Dobson's own instruments remains on display in the University of Oxford Department of Physics.

Dobson spectrophotometers can be used to measure both total column ozone and profiles of ozone in the atmosphere. Ozone is tri-atomic oxygen, O3; ozone molecules absorb harmful UV light in the atmosphere before it reaches the surface of the earth. No UVC radiation penetrates to the ground as it is absorbed in the ozone-oxygen cycle. However some longer-wave and less harmful UVB and most of the UVA is not absorbed as ozone is less opaque to these frequencies, so they penetrate to the ground level of Earth in higher quantities. The sources of light used may vary. Beside the direct sun light, the light from the clear sky, moon or stars may be used.

The Dobson Spectrometer measures the total ozone by measuring the relative intensity of the UVB radiation that reaches the Earth and comparing it to that of UVA radiation at ground level. If all of the ozone were removed from the atmosphere, the amount of UVB radiation would equal the amount of UVA radiation on the ground. As ozone does exist in the atmosphere, the Dobson Spectrometer can use the ratio between UVA and UVB radiation on the ground to determine how much ozone is present in the upper atmosphere to absorb the UVC radiation.

The ratio is determined by turning the R-dial, which can be rotated a full 300°, on the instrument. The spectrometer compares two different wavelength intensities, UVB (305 nm) and UVA (325 nm), in order to calculate the amount of ozone. When turned, the R-dial filters and blocks out the light of the UVC wavelength until the intensity of the two wavelengths of light are equal. The ratio of the two wavelengths at incidence can be calculated once the filtered intensities are the same. The results are measured in Dobson Units, equal to 10 µm thickness of ozone compressed to Standard conditions for temperature and pressure (STP) in the column. If all of the ozone in the atmospheric column one was measuring were compressed to STP, the thickness of the compressed atmosphere in mm would equal an answer in Dobson Units divided by 100.


...
Wikipedia

...