Direct Memory Access

Direct memory access (DMA) is a feature of computer systems that allows certain hardware subsystems to access main system memory (RAM), independent of the central processing unit (CPU).

Without DMA, when the CPU is using programmed input/output, it is typically fully occupied for the entire duration of the read or write operation, and is thus unavailable to perform other work. With DMA, the CPU first initiates the transfer, then it does other operations while the transfer is in progress, and it finally receives an interrupt from the DMA controller when the operation is done. This feature is useful at any time that the CPU cannot keep up with the rate of data transfer, or when the CPU needs to perform useful work while waiting for a relatively slow I/O data transfer. Many hardware systems use DMA, including disk drive controllers, graphics cards, network cards and sound cards. DMA is also used for intra-chip data transfer in multi-core processors. Computers that have DMA channels can transfer data to and from devices with much less CPU overhead than computers without DMA channels. Similarly, a processing element inside a multi-core processor can transfer data to and from its local memory without occupying its processor time, allowing computation and data transfer to proceed in parallel.

DMA can also be used for "memory to memory" copying or moving of data within memory. DMA can offload expensive memory operations, such as large copies or scatter-gather operations, from the CPU to a dedicated DMA engine. An implementation example is the I/O Acceleration Technology.

Standard DMA, also called third-party DMA, uses a DMA controller. A DMA controller can generate memory addresses and initiate memory read or write cycles. It contains several hardware registers that can be written and read by the CPU. These include a memory address register, a byte count register, and one or more control registers. The control registers could specify the source, the destination, the direction of the transfer (reading from the I/O device or writing to the I/O device), the size of the transfer unit, and/or the number of bytes to transfer in one burst depending on what features the DMA controller provides.

...
Wikipedia