*** Welcome to piglix ***

DBm


dBm (sometimes dBmW or decibel-milliwatts) is an abbreviation for the power ratio in decibels (dB) of the measured power referenced to one milliwatt (mW). It is used in radio, microwave and fiber-optical networks as a convenient measure of absolute power because of its capability to express both very large and very small values in a short form. Compare dBW, which is referenced to one watt (1000 mW).

Since it is referenced to the watt, it is an absolute unit, used when measuring absolute power. By comparison, the decibel (dB) is a dimensionless unit, used for quantifying the ratio between two values, such as signal-to-noise ratio.

In audio and telephony, dBm is typically referenced relative to a 600-ohm impedance, while in radio-frequency work dBm is typically referenced relative to a 50-ohm impedance.

A power level of 0 dBm corresponds to a power of 1 milliwatt. A 10 dB increase in level is equivalent to 10 times the power. A 3 dB increase in level is approximately equivalent to doubling the power, which means that a level of 3 dBm corresponds roughly to a power of 2 mW. For each 3 dB decrease in level, the power is reduced by about one half, making −3 dBm correspond to a power of about 0.5 mW.

To express an arbitrary power P in mW as x in dBm, or vice versa, the following equivalent expressions may be used:

idem with P in watts

Below is a table summarizing useful cases:

Typical maximal output RF power from a ham radio HF transceiver

Maximal output from a GSM850/900 mobile phone

DCS or GSM 1800/1900 MHz mobile phone. EIRP IEEE 802.11a (20 MHz-wide channels) in either 5 GHz subband 2 (5,470–5,725 MHz) provided that transmitters are also IEEE 802.11h-compliant, or U-NII-3 (5,725–5,825 MHz). The former is EU only, the latter is US only. Also, maximal power allowed by the FCC for American amateur radio licensees to fly radio-controlled aircraft or operate RC models of any other type on the amateur radio bands in the US.


...
Wikipedia

...