Computerized classification test

A computerized classification test (CCT) refers to, as its name would suggest, a test that is administered by computer for the purpose of classifying examinees. The most common CCT is a mastery test where the test classifies examinees as "Pass" or "Fail," but the term also includes tests that classify examinees into more than two categories. While the term may generally be considered to refer to all computer-administered tests for classification, it is usually used to refer to tests that are interactively administered or of variable-length, similar to computerized adaptive testing (CAT). Like CAT, variable-length CCTs can accomplish the goal of the test (accurate classification) with a fraction of the number of items used in a conventional fixed-form test.

A CCT requires several components:

The starting point is not a topic of contention; research on CCT primarily investigates the application of different methods for the other three components. Note: The termination criterion and scoring procedure are separate in CAT, but the same in CCT because the test is terminated when a classification is made. Therefore, there are five components that must be specified to design a CAT.

An introduction to CCT is found in Thompson (2007) and a book by Parshall, Spray, Kalohn and Davey (2006). A bibliography of published CCT research is found below.

A CCT is very similar to a CAT. Items are administered one at a time to an examinee. After the examinee responds to the item, the computer scores it and determines if the examinee is able to be classified yet. If they are, the test is terminated and the examinee is classified. If not, another item is administered. This process repeats until the examinee is classified or another ending point is satisfied (all items in the bank have been administered, or a maximum test length is reached).

Two approaches are available for the psychometric model of a CCT: classical test theory (CTT) and item response theory (IRT). Classical test theory assumes a state model because it is applied by determining item parameters for a sample of examinees determined to be in each category. For instance, several hundred "masters" and several hundred "nonmasters" might be sampled to determine the difficulty and discrimination for each, but doing so requires that you be able to easily identify a distinct set of people that are in each group. IRT, on the other hand, assumes a trait model; the knowledge or ability measured by the test is a continuum. The classification groups will need to be more or less arbitrarily defined along the continuum, such as the use of a cutscore to demarcate masters and nonmasters, but the specification of item parameters assumes a trait model.

...
Wikipedia