Cabane strut

In aeronautics, bracing comprises additional structural members which stiffen the functional airframe to give it rigidity and strength under load. Bracing may be applied both internally and externally, and may take the form of strut, which act in compression or tension as the need arises, and/or wires, which act only in tension.

In general, bracing allows a stronger, lighter structure than one which is unbraced, but external bracing in particular adds drag which slows down the aircraft and raises considerably more design issues than internal bracing. Another disadvantage of bracing wires is that they require routine checking and adjustment, or rigging, even when located internally.

During the early years of aviation, bracing was a universal feature of all forms of aeroplane, including the monoplanes and biplanes which were then equally common. Today, bracing in the form of lift struts is still used for some light commercial designs where a high wing and light weight are more important than ultimate performance.

Bracing works by creating a triangulated truss structure which resists bending or twisting. By comparison, an unbraced cantilever structure bends easily unless it carries a lot of heavy reinforcement. Making the structure deeper allows it to be much lighter and stiffer. To reduce weight and air resistance, the structure may be made hollow, with bracing connecting the main parts of the airframe. For example, a high-wing monoplane may be given a diagonal lifting strut running from the bottom of the fuselage to a position far out towards the wingtip. This increases the effective depth of the wing root to the height of the fuselage, making it much stiffer for little increase in weight.

Typically, the ends of bracing struts are joined to the main internal structural components such as a wing spar or a fuselage bulkhead, and bracing wires are attached close by.

Bracing may be used to resist all the various forces which occur in an airframe, including lift, weight, drag and twisting or torsion. A strut is a bracing component stiff enough to resist these forces whether they place it under compression or tension. A wire is a bracing component able only to resist tension, going slack under compression, and consequently is nearly always used in conjunction with struts.

A square frame made of solid bars is not rigid but tends to bend at the corners. Bracing it with an extra diagonal bar would be heavy. A wire would be much lighter but would stop it collapsing only one way. To hold it rigid, two cross-bracing wires are needed. This method of cross-bracing can be seen clearly on early biplanes, where the wings and interplane struts form a rectangle which is cross-braced by wires.

...
Wikipedia