*** Welcome to piglix ***

Brace (tool)


A brace is a hand tool used with a bit (drill bit or auger) to holes, usually in wood. Pressure is applied to the top and the tool is rotated with a U-shaped grip.

The U-shaped part is a kind of crank. It gives the brace much greater torque than other kinds of hand-powered drills. A brace and bit can be used to drill much wider and deeper holes than can a geared hand-powered drill. The price of the greater torque is lower rotational speed; it is easy for a geared hand drill to achieve a rotational speed of several hundred revolutions per minute, but it requires considerable effort to achieve even 100 rpm with a brace.

The front part of the brace consists of a chuck spindle with V-shaped brackets or clamps inside. Turning the spindle of the chuck in a clockwise direction tightens the drill bit in the chuck and turning in a counter-clockwise direction loosens the bit for removal.

In most braces, immediately behind the chuck is a three position gear release which allows ratcheting of the handle when in tight spots. Turning the gear release from the center position allows ratcheting the brace in the direction needed. Turning the gear release fully clockwise lets it remove wood in a clockwise direction with the ratchet action going counter-clockwise. Placing the gear release fully counter-clockwise then allows turning the brace and bit in a counter-clockwise direction, usually to remove the drill bit from the hole. The center position of the gear release prohibits the ratcheting effect.

The U-shaped crank has a wooden spindle on it and—along with the top spindle—is allowed to freely turn under the hands without producing wear and tear on the hands (thus, no blisters).

The earliest carpenter's braces equipped with a U-shaped grip, that is with a compound crank, appeared between 1420 and 1430 in Flanders.


...
Wikipedia

...