Bezel setting

The bezel of a ring is a wider and usually thicker section of the hoop, which may contain a flat surface, usually with an engraved design, as in a signet ring, or a gem. The ring is normally worn to display the bezel on the upper or outer side of the finger. The word may also refer to a bezel setting for a stone, which is a general term for a setting holding the stone in place using a raised surrounding for the stone with a lip encircling and overlapping the edges of the stone, thus holding it in place. Modern bezel settings typically use a band of metal containing a groove and a flange (i.e. projecting lip) to hold a watch crystal or gemstone in its setting. This was the earliest method of setting gemstones into jewelry, in historic examples often made by leaving a hole or slot in the ring with a thin lip which was bent over once the stone was inserted, holding it in place. An extension of the word used in this sense can refer to a rotatable rim on a clock or watch used to indicate certain data such as elapsed time.

Other types of bezels, less used in modern jewelry, are "swivel bezels" where the bezel, perhaps just formed of a stone with a metal rod through it, can rotate, and "box bezels", where a "box" or cage forms the bezel, often sitting on the main ring hoop, and perhaps open at the top where there is a stone.

In gem-cutting bezel may also refer to the sloping faces of a cut stone round the flat "table" face (another meaning of the word is the sloping face of a chisel).

More broadly, bezels are found on tools and appliances. It is the diagonal face at the end of the blade of a chisel, or similar implement, leading to the edge. In vehicles, it is the part of the vehicle's bodywork that surrounds a headlight or turn signal. On a cell phone, it is the back surface that frames the LCD screen.

In making a typical modern bezel setting the bezel is shaped into the size and shape of the gem and then soldered into place on the metal of the jewelry. The prepared stone is then placed into the bezel and the metal is pressed down over the edges of stone, locking it into place.

A cabochon stone, a gemstone that is not faceted, usually relies on the shallow angle cut into the side of the stone which helps the metal to stay in place. With a clear faceted stone, such as a diamond, a shallow groove is cut into the bezel itself. The girdle or widest part of the gem stone is placed in the bezel, which is then pushed down over the girdle. The pressure of the bezel over the edge of the diamond keeps it in place.

...
Wikipedia