Air & Space 18A
| Air & Space 18A | |
|---|---|
 |
|
| Role | Autogyro |
| Manufacturer | Air and Space Manufacturing, Inc. |
| Designer | Gilbert Devore |
| First flight | 1964 |
| Introduction | 1965 |
| Status | Out of production |
| Produced | 1965-2000 |
| Number built | 68 |
| Unit cost |
~$185,000
|
 Jump takeoff of A&S 18A |
The Air & Space 18A is a gyroplane that was manufactured in the central United States between 1965 and 2000.
The Air & Space 18A is one of the last three gyroplanes issued a Standard Airworthiness Certificate (September 1961) by the United States Federal Aviation Administration (FAA).
Raymond E. Umbaugh, a manufacturer of agricultural fertilizer, founded Umbaugh Aircraft Corporation in Ocala, Florida, in 1957 to develop a gyroplane based on experience he acquired while modifying single-seat Bensen Gyrocopters. Gilbert Devore commenced the design of Umbaugh's tandem two-seat jump-takeoff gyroplane in 1958, basing the rotor system on that of the Sznycer Omega BS-12 helicopter. The prototype Umbaugh U-17, built by Fairchild Engine and Airplane Corporation of Hagerstown, Maryland, flew in August 1959. Further test flights were conducted by chief pilot Ken Hayden and former Pitcairn Autogiro Company pilot Slim Soule. The majority of the testing of the aircraft was done at Bartow Air Base in Bartow,Fl. The prototype exhibited stability problems due to its single rudder and minimal T-tail horizontal stabilizer positioned on a boom behind the pusher propeller. The second prototype, named Umbaugh U-18, was fitted with a V-tail which also proved inadequate. The third empennage tested, also unsuccessfully, was a T-tail with two large vertical end plates on the horizontal tail plane. Sufficient stability was finally achieved by the use of two fixed vertical fins with a centrally mounted all-flying rudder, all mounted on a horizontal stabilizer. Umbaugh had by this time concluded an agreement for Fairchild Engine and Airplane Corporation to undertake final development and mass production of the U-18 as the “Flymobil.”
Fairchild built five development gyroplanes during 1960, one of which was used to gain FAA Approved Type Certificate 1H17 in September 1961. Umbaugh established a large network of dealers and distributors in the United States, upon whom he imposed minimum sales quotas to generate a large order backlog, but he experienced difficulty filling the orders due to inadequate manufacturing capability at Fairchild. Under pressure from the dealers, Umbaugh Aircraft Corporation ceased operations in 1962 and the agreement with Fairchild was terminated.
...
Wikipedia