Flashing (weatherproofing)

Flashing refers to thin pieces of impervious material installed to prevent the passage of water into a structure from a joint or as part of a weather resistant barrier (WRB) system.

The origin of flash and flashing are uncertain, but may come from the Middle English verb flasshen, 'to sprinkle, splash', related to flask.

Counter-flashing (or cover flashing, cap flashing) is a term used when there are two parallel pieces of flashing employed together such as on a chimney, where the counter-flashing is built into the chimney and overlaps a replaceable piece of base flashing. Strips of lead used for flashing an edge were sometimes called an apron, and the term is still used for the piece of flashing below a chimney. The up-hill side of a chimney may have a small gable-like assembly called a cricket with cricket flashing or on narrow chimneys with no cricket a back flashing or back pan flashing. Flashing may be let into a groove in a wall or chimney called a reglet.

Before the availability of sheet products for flashing carpenters used creative methods to minimize water penetration such as angling roof shingles away from the joint, placing chimneys at the ridge, and building steps into the sides of chimneys to throw off water. The introduction of manufactured flashing decreased water penetration at obstacles such as chimneys, vent pipes, walls which abut roofs, window and door openings, etc. thus making buildings more durable and reducing indoor mold problems. In builders books, by 1832 Loudons An Encyclopædia of Cottage, Farm, and Villa Architecture and Furniture... gives instruction on installing lead flashing and 1875 Notes on Building Construction gives detailed instruction and is well illustrated with methods still used today.

Flashing may be exposed or concealed. Exposed flashing is usually of a sheet metal and concealed flashing may be metal or a flexible, adhesive backed, material particularly around wall penetrations such as window and door openings.

In earlier days, birch bark was occasionally used as a flashing material. Most flashing materials today are metal, plastic, rubber, or impregnated paper.

Metal flashing materials include lead, aluminium, copper, stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminum, terne-coated copper, galvalume (aluminum-zinc alloy coated sheet steel), and metals similar to stone-coated metal roofing. Metal flashing should be provided with expansion joints on long runs to prevent deformation of the metal sheets due to expansion and contraction, and should not stain or be stained by adjacent materials or react chemically with them. An important type of potential chemical reaction between metal flashing materials is galvanic corrosion. Copper and lead cannot be used in contact with or even above aluminum, zinc, or coated steel without an increased risk of premature corrosion. Also, Aluminum and zinc flashing cannot be used in contact with pressure treated wood due to rapid corrosion. Aluminum is also damaged by wet mortar and wet plaster. Salt spray in coastal areas may accelerate corrosion. so stainless steel, copper, or coated aluminum are recommended flashing materials near salt water.

...
Wikipedia