*** Welcome to piglix ***

Intratec TEC-DC9

TEC-9 / TEC-DC9 / AB-10
Kg99.jpg
Intratec TEC-9 (AB-10 Shown)
Type Semi-automatic pistol
Place of origin
Production history
Designer George Kellgren
Manufacturer Intratec
Produced 1985–2001
Number built 257,434
Variants
  • KG-9
  • KG-99
  • TEC DC-9
  • TEC DC-9M
  • AB-10
  • TEC-9M (Mini, 76 mm barrel, no barrel jacket, 20-round magazine)
  • TEC-9S (stainless steel)
Specifications
Weight 1.23–1.4 kg depending on model
Length 241–317 mm depending on model
Barrel length 76–127 mm depending on model

Cartridge 9×19mm Parabellum
Caliber 9mm
Action Blowback-operated, semi-automatic pistol
Muzzle velocity 1,181 ft/s (360 m/s)
Effective firing range 50 m (160 ft)
Feed system 10-, 20-, 32-, 36- and 50-round box magazine, 72-round drum magazine
Sights Iron sight

The Intratec TEC-9, TEC-DC9, or AB-10 is a blowback-operated semi-automatic pistol. It was designed by Intratec, an American offshoot of Interdynamic AB. The TEC-9 was made of inexpensive molded polymers and a mixture of stamped and milled steel parts. The simple design of the gun made it easy to repair and modify.

Swedish company Interdynamic AB of Stockholm designed the Interdynamic MP-9 9mm submachine gun. Interdynamic intended it as an inexpensive submachine gun based on the Carl Gustav M/45 for military applications, but did not find a government buyer, so it was taken to the U.S. market as an open-bolt semi-automatic KG-9 pistol. The open-bolt design was too easy to convert to full-auto. Because of this, the ATF forced Interdynamic to redesign it into a closed-bolt system, which was harder to convert to full-auto. This variant was called the KG-99. It made frequent appearances on Miami Vice, where it was legally converted to full-auto by Title II manufacturers. The KG-9 and KG-99 have an open-end upper receiver tube where the bolt, recoil springs, and buffer plate are held in place by the plastic/polymer lower receiver frame. This design only allows for 115 grain 9mm ammo. If heavier grain ammo or hot loads are used, the plastic lower receiver will fail or crack, rendering the firearm unusable. The later model TEC-9 and AB-10 have a threaded upper receiver tube at the rear and a screw-on end cap to contain the bolt, recoil spring, and buffer plate even if removed from the lower receiver. This solves the problem of lower receiver failure when using hot ammo.

The TEC-9 was produced from 1985 to 1994.

After the Cleveland School massacre, the TEC-9 was in California's list of banned weapons. To circumvent this, Intratec rebranded a variant of the TEC-9 as the TEC-DC9 from 1990 to 1994 (DC standing for "Designed for California"). The most noticeable external difference between the TEC-9 and the later TEC-DC9 is that rings to hold the sling were moved from the side of the gun with the cocking handle, to a removable stamped metal clip in the back of the gun. The TEC-9 and TEC-DC9 are otherwise identical.


...
Wikipedia

...