*** Welcome to piglix ***

CT Value


CT Values are an important part of calculating disinfectant dosage for the chlorination of drinking water. A CT value is the product of the concentration of a disinfectant (e.g. free chlorine) and the contact time with the water being disinfected. It is typically expressed in units of mg-min/L.

The goal of disinfection is the inactivation of microorganisms. This depends on: the microorganism, the disinfectant being used, the concentration of the disinfectant, the contact time, and the temperature and pH of the water.

The disinfection kinetics are conventionally calculated via the Chick-Watson model, named for the work of Harriette Chick and H.E. Watson. This model is expressed by the following equation:

Where:

The survival ratio is commonly expressed as an inactivation ratio (in %) or as the number of reductions in the order of magnitude of the microorganism concentration. For example, a situation where N0=107CFU/L and N=104 CFU/L would be reported as a 99.9% inactivation or "3-log10" removal.

In water treatment practice, tables of the product C×t are used to calculate disinfection dosages. These tables express the required CT values to achieve a desired removal of microorganisms of interest in drinking water (e.g. Giardia lamblia cysts) for a given disinfectant under constant temperature and pH conditions. A portion of such a table is reproduced below.

CT Values for the Inactivation of Giardia Cysts by Free Chlorine at 5 °C and pH ≈ 7.0:

Full tables are much larger than this example and should be obtained from the regulatory agency for a particular jurisdiction.


...
Wikipedia

...