Free Ads! if you are a small business with annual revenues of less than $1M - piglix.com will place your ads free of charge for up to one year! ... read more
$2,000 in free prizes! piglix.com is giving away ten (10) Meccano Erector sets, retail at $200 each, that build a motorized Ferris Wheel (or one of 22 other models) ... see details
Engineering notation is a version of scientific notation in which the exponent of ten must be divisible by three (i.e., they are powers of a thousand, but written as, for example, 106 instead of 10002). As an alternative to writing powers of 10, SI prefixes can be used, which also usually provide steps of a factor of a thousand. On calculators, engineering notation is named "ENG".
Compared to normalized scientific notation, one disadvantage of using SI prefixes and engineering notation is that significant figures are not always readily apparent. For example, 500 µm and 500 × 10−6 m cannot express the uncertainty distinctions between 5 × 10−4 m, 5.0 × 10−4 m, and 5.00 × 10−4 m. This can be solved by changing the range of the coefficient in front of the power from the common 1–1000 to 0.001–1.0. In some cases this may be suitable; in others it may be impractical. In the previous example, 0.5 mm, 0.50 mm, or 0.500 mm would have been used to show uncertainty and significant figures. It is also common to state the precision explicitly, such as "47 kΩ ±5%"
Another example: when the speed of light (exactly 792458 m/s by the definition of the meter and second) is expressed as 3.00 × 108 m/s or 3.00 × 105 km/s then it is clear that it is between 299 500 km/s and 300 500 km/s, but when using 300 × 106 m/s, or 300 × 103 km/s, 300 000 km/s, or the unusual but short 300 Mm/s, this is not clear. A possibility is using 0.300 Gm/s, convenient to write, but somewhat impractical in understanding (writing something large as a fraction of something even larger; in a context of larger numbers expressed in the same unit this could be convenient, but that is not applicable here). 299
On the other hand, Engineering notation allows the numbers to explicitly match their corresponding SI prefixes, which facilitates reading and oral communication. For example, 12.5×10−9 m can be read as "twelve-point-five nanometers" and written as 12.5 nm, while its scientific notation equivalent 1.25×10−8 m would likely be read out as "one-point-two-five times ten-to-the-negative-eight meters".
Engineering notation, like scientific notation generally, can use the E notation, such that
Don't forget! that as one of our early users, you are eligible to receive the 1,000 point bonus as soon as you have created five (5) acceptable piglix.